2008–2015 Mitsubishi Lancer Evolution Wheel & Tire Fitment Guide
X generation, GSR. 5x114.3 bolt pattern, stock 18×8.5 ET38 on 245/40R18. Compare 3 popular upgrades or try your own size.
Specs
| Bolt pattern | 5x114.3 |
|---|---|
| Center bore | 67.1 mm |
| Lug thread | M12x1.5 |
| Reference trim | GSR |
| Stock wheel | 18×8.5 ET38 |
| Stock tire | 245/40R18 |
| Stock overall diameter | 25.72 in |
Calculator
Starts on the stock setup. Drag the sliders or load one of the popular upgrades below.
The small mark on each slider shows the current value. Type in the box for sizes outside the slider range.
Custom vehicle measurementsOptional
Measure with your current wheels on the car and the results below show how much room the new setup leaves. The drawings use your numbers too. Leave blank anything you haven't measured.
- Park on level ground at normal ride height, wheels straight.
- Front and rear differ. Measure the axle you're changing, or enter the tighter corner.
Millimetres or centimetres are recommended: small gaps are easier to read accurately than inch marks.
Narrowest gap between the inside of the tire (or wheel, whichever sits further in) and the strut, spring perch or upper control arm. Wheels pointed straight.
Hang a plumb line or hold a straightedge vertically from the fender lip above the hub, then measure across to the outermost point of the tire or wheel. Enter a negative number if it already sticks out.
Straight up from the top of the tire to the fender lip, with the car on the ground at normal ride height.
Smallest gap between the outer edge of the brake caliper and the inside of the wheel barrel.
- Poke
- 0mm
- Wheel face stays where it is.
- Inner clearance
- 0mm
- Same room to the suspension.
- Overall diameter
- 0%
- 0 in, within ±3%.
- Speedo reads 60
- 60mph
- Your actual speed.
| Vehicle | Mitsubishi Lancer Evolution GSR | ||
|---|---|---|---|
| Bolt pattern | 5x114.3 | Hub bore | 67.1 mm |
| Current | 18×8.5 ET38, 245/40R18 | New | 18×8.5 ET38, 245/40R18 |
Popular upgrades
Each size compared with the stock 18×8.5 ET38, 245/40R18.
| Setup | Poke | Inner clearance | Diameter | Speedo reads 60 | Action |
|---|---|---|---|---|---|
| Square 18×9.518×9.5 ET38, 255/35R18 | +12.7 mm | −12.7 mm | −2.7% | 58.4 mph | |
| Track 18×9.518×9.5 ET22, 265/35R18 | +28.7 mm | +3.3 mm | −1.6% | 59 mph | |
| Wide 18×9.518×9.5 ET22, 275/35R18 | +28.7 mm | +3.3 mm | −0.5% | 59.7 mph |
Notes
- GSR uses Enkei 18×8.5 ET38 and MR uses forged BBS 18×8.5 ET38; both run 245/40R18.
- The Brembo front brakes need 18-in wheels at minimum, and some spoke designs need a 3 mm spacer to clear the calipers.
- 18×9.5 ET22 with 265–275/35R18 needs negative camber and rolled rear fenders when lowered; with ET38, 255/35 or 235/40 is safer than 265/35.
Questions
What bolt pattern does a 2008–2015 Mitsubishi Lancer Evolution use?
The 2008–2015 Mitsubishi Lancer Evolution uses a 5x114.3 bolt pattern with a 67.1 mm center bore and M12x1.5 lug threads.
What size wheels and tires are stock on the 2008–2015 Mitsubishi Lancer Evolution GSR?
The 2008–2015 Mitsubishi Lancer Evolution GSR came with 18×8.5 ET38 wheels and 245/40R18 tires, about 25.7 inches in overall diameter.
How far does a 18×9.5 ET22 wheel stick out on a 2008–2015 Mitsubishi Lancer Evolution?
On the 2008–2015 Mitsubishi Lancer Evolution, compared with the stock 18×8.5 ET38, a 18×9.5 ET22 sits 28.7 mm further out at the outer lip and 3.3 mm further from the suspension at the inner barrel.
Which 2008–2015 Mitsubishi Lancer Evolution wheel and tire upgrade keeps the speedometer most accurate?
Of the 2008–2015 Mitsubishi Lancer Evolution upgrades listed here, 18×9.5 ET22 · 275/35R18 is closest to the stock 245/40R18, changing overall diameter by −0.5%. At an indicated 60 mph you would actually be doing 59.7 mph.
Do aftermarket wheels need hub-centric rings on a 2008–2015 Mitsubishi Lancer Evolution?
The 2008–2015 Mitsubishi Lancer Evolution's hub bore is 67.1 mm. Wheels machined to exactly 67.1 mm center on the hub directly; wheels with a larger bore need 67.1 mm hub-centric rings to avoid vibration.
Also on 5x114.3
These share the bolt pattern. Check offset, hub bore and brake clearance before swapping wheels.
| Vehicle | Generation | Bolt pattern | Hub bore |
|---|---|---|---|
| 2003–2006 Mitsubishi Lancer Evolution | VIII/IX (CT9A) | 5x114.3 | 67.1 mm |
| 2019+ Genesis G70 | 1st gen (IK) | 5x114.3 | 67.1 mm |
| 2018–2023 Kia Stinger | CK | 5x114.3 | 67.1 mm |
| 2010–2013 Mazda Mazdaspeed3 | BL | 5x114.3 | 67.1 mm |
| 1993–1995 Mazda RX-7 | FD | 5x114.3 | 67.1 mm |
| 2025+ Hyundai Ioniq 5 N | NE | 5x114.3 | 67.1 mm |