2003–2006 Mitsubishi Lancer Evolution Wheel & Tire Fitment Guide

VIII/IX (CT9A) generation, MR. 5x114.3 bolt pattern, stock 17×8 ET38 on 235/45R17. Compare 3 popular upgrades or try your own size.

Specs

Bolt pattern5x114.3
Center bore67.1 mm
Lug threadM12x1.5
Reference trimMR
Stock wheel17×8 ET38
Stock tire235/45R17
Stock overall diameter25.33 in

Calculator

Starts on the stock setup. Drag the sliders or load one of the popular upgrades below.

Wheel
in
in
mm
Tire
mm
%

The small mark on each slider shows the current value. Type in the box for sizes outside the slider range.

Custom vehicle measurementsOptional

Measure with your current wheels on the car and the results below show how much room the new setup leaves. The drawings use your numbers too. Leave blank anything you haven't measured.

  • Park on level ground at normal ride height, wheels straight.
  • Front and rear differ. Measure the axle you're changing, or enter the tighter corner.
ABCD

Millimetres or centimetres are recommended: small gaps are easier to read accurately than inch marks.

mm

Narrowest gap between the inside of the tire (or wheel, whichever sits further in) and the strut, spring perch or upper control arm. Wheels pointed straight.

mm

Hang a plumb line or hold a straightedge vertically from the fender lip above the hub, then measure across to the outermost point of the tire or wheel. Enter a negative number if it already sticks out.

mm

Straight up from the top of the tire to the fender lip, with the car on the ground at normal ride height.

mm

Smallest gap between the outer edge of the brake caliper and the inside of the wheel barrel.

Front section
StrutBrakeFender139.6Backspacing63.6 Frontspacing
Three-quarter view
235/45R17
New setupCurrent setupFender and strut are drawn 12 mm outside and 28 mm inside your current setup. Add your own measurements for real clearance.
Poke
0mm
Wheel face stays where it is.
Inner clearance
0mm
Same room to the suspension.
Overall diameter
0%
0 in, within ±3%.
Speedo reads 60
60mph
Your actual speed.
VehicleMitsubishi Lancer Evolution MR
Bolt pattern5x114.3Hub bore67.1 mm
Current17×8 ET38, 235/45R17New17×8 ET38, 235/45R17

Notes

Questions

What bolt pattern does a 2003–2006 Mitsubishi Lancer Evolution use?

The 2003–2006 Mitsubishi Lancer Evolution uses a 5x114.3 bolt pattern with a 67.1 mm center bore and M12x1.5 lug threads.

What size wheels and tires are stock on the 2003–2006 Mitsubishi Lancer Evolution MR?

The 2003–2006 Mitsubishi Lancer Evolution MR came with 17×8 ET38 wheels and 235/45R17 tires, about 25.3 inches in overall diameter.

How far does a 17×9 ET22 wheel stick out on a 2003–2006 Mitsubishi Lancer Evolution?

On the 2003–2006 Mitsubishi Lancer Evolution, compared with the stock 17×8 ET38, a 17×9 ET22 sits 28.7 mm further out at the outer lip and 3.3 mm further from the suspension at the inner barrel.

Which 2003–2006 Mitsubishi Lancer Evolution wheel and tire upgrade keeps the speedometer most accurate?

Of the 2003–2006 Mitsubishi Lancer Evolution upgrades listed here, 17×9 ET22 · 255/40R17 is closest to the stock 235/45R17, changing overall diameter by −1.2%. At an indicated 60 mph you would actually be doing 59.3 mph.

Do aftermarket wheels need hub-centric rings on a 2003–2006 Mitsubishi Lancer Evolution?

The 2003–2006 Mitsubishi Lancer Evolution's hub bore is 67.1 mm. Wheels machined to exactly 67.1 mm center on the hub directly; wheels with a larger bore need 67.1 mm hub-centric rings to avoid vibration.

Also on 5x114.3

These share the bolt pattern. Check offset, hub bore and brake clearance before swapping wheels.

VehicleGenerationBolt patternHub bore
2008–2015 Mitsubishi Lancer EvolutionX5x114.367.1 mm
2019+ Genesis G701st gen (IK)5x114.367.1 mm
2018–2023 Kia StingerCK5x114.367.1 mm
2010–2013 Mazda Mazdaspeed3BL5x114.367.1 mm
1993–1995 Mazda RX-7FD5x114.367.1 mm
2025+ Hyundai Ioniq 5 NNE5x114.367.1 mm