2025+ Hyundai Ioniq 5 N Wheel & Tire Fitment Guide
NE generation, base. 5x114.3 bolt pattern, stock 21×9.5 ET45 on 275/35R21. Compare 3 popular upgrades or try your own size.
Specs
| Bolt pattern | 5x114.3 |
|---|---|
| Center bore | 67.1 mm |
| Lug thread | M14x1.5 |
| Reference trim | base |
| Stock wheel | 21×9.5 ET45 |
| Stock tire | 275/35R21 |
| Stock overall diameter | 28.58 in |
Calculator
Starts on the stock setup. Drag the sliders or load one of the popular upgrades below.
The small mark on each slider shows the current value. Type in the box for sizes outside the slider range.
Custom vehicle measurementsOptional
Measure with your current wheels on the car and the results below show how much room the new setup leaves. The drawings use your numbers too. Leave blank anything you haven't measured.
- Park on level ground at normal ride height, wheels straight.
- Front and rear differ. Measure the axle you're changing, or enter the tighter corner.
Millimetres or centimetres are recommended: small gaps are easier to read accurately than inch marks.
Narrowest gap between the inside of the tire (or wheel, whichever sits further in) and the strut, spring perch or upper control arm. Wheels pointed straight.
Hang a plumb line or hold a straightedge vertically from the fender lip above the hub, then measure across to the outermost point of the tire or wheel. Enter a negative number if it already sticks out.
Straight up from the top of the tire to the fender lip, with the car on the ground at normal ride height.
Smallest gap between the outer edge of the brake caliper and the inside of the wheel barrel.
- Poke
- 0mm
- Wheel face stays where it is.
- Inner clearance
- 0mm
- Same room to the suspension.
- Overall diameter
- 0%
- 0 in, within ±3%.
- Speedo reads 60
- 60mph
- Your actual speed.
| Vehicle | Hyundai Ioniq 5 N base | ||
|---|---|---|---|
| Bolt pattern | 5x114.3 | Hub bore | 67.1 mm |
| Current | 21×9.5 ET45, 275/35R21 | New | 21×9.5 ET45, 275/35R21 |
Popular upgrades
Each size compared with the stock 21×9.5 ET45, 275/35R21.
| Setup | Poke | Inner clearance | Diameter | Speedo reads 60 | Action |
|---|---|---|---|---|---|
| Track 20×9.520×9.5 ET38, 275/40R20 | +7 mm | +7 mm | +0.3% | 60.2 mph | |
| Flush 20×9.5 +3520×9.5 ET35, 275/40R20 | +10 mm | +10 mm | +0.3% | 60.2 mph | |
| Wide 21×10.521×10.5 ET45, 275/35R21 | +12.7 mm | −12.7 mm | 0% | 60 mph |
Notes
- Square setup from the factory: forged 21×9.5 ET45 on 275/35R21 Pirelli P Zero at all four corners.
- The large front brakes limit smaller wheels: owners treat 20-inch as the practical minimum, and 19s only fit if the wheel is designed for big-brake clearance.
- Uses M14x1.5 lug nuts with a conical seat; 67.1 mm hub bore, so wheels with a 73.1 mm bore need rings.
- The mbDESIGN 21×10.5 ET45 build used lowering springs and 20 mm rear spacers.
Questions
What bolt pattern does a 2025+ Hyundai Ioniq 5 N use?
The 2025+ Hyundai Ioniq 5 N uses a 5x114.3 bolt pattern with a 67.1 mm center bore and M14x1.5 lug threads.
What size wheels and tires are stock on the 2025+ Hyundai Ioniq 5 N base?
The 2025+ Hyundai Ioniq 5 N base came with 21×9.5 ET45 wheels and 275/35R21 tires, about 28.6 inches in overall diameter.
How far does a 21×10.5 ET45 wheel stick out on a 2025+ Hyundai Ioniq 5 N?
On the 2025+ Hyundai Ioniq 5 N, compared with the stock 21×9.5 ET45, a 21×10.5 ET45 sits 12.7 mm further out at the outer lip and 12.7 mm closer to the suspension at the inner barrel.
Which 2025+ Hyundai Ioniq 5 N wheel and tire upgrade keeps the speedometer most accurate?
Of the 2025+ Hyundai Ioniq 5 N upgrades listed here, 21×10.5 ET45 · 275/35R21 is closest to the stock 275/35R21, changing overall diameter by 0%. At an indicated 60 mph you would actually be doing 60 mph.
Do aftermarket wheels need hub-centric rings on a 2025+ Hyundai Ioniq 5 N?
The 2025+ Hyundai Ioniq 5 N's hub bore is 67.1 mm. Wheels machined to exactly 67.1 mm center on the hub directly; wheels with a larger bore need 67.1 mm hub-centric rings to avoid vibration.
Also on 5x114.3
These share the bolt pattern. Check offset, hub bore and brake clearance before swapping wheels.
| Vehicle | Generation | Bolt pattern | Hub bore |
|---|---|---|---|
| 2019+ Genesis G70 | 1st gen (IK) | 5x114.3 | 67.1 mm |
| 2018–2023 Kia Stinger | CK | 5x114.3 | 67.1 mm |
| 2010–2013 Mazda Mazdaspeed3 | BL | 5x114.3 | 67.1 mm |
| 1993–1995 Mazda RX-7 | FD | 5x114.3 | 67.1 mm |
| 2003–2006 Mitsubishi Lancer Evolution | VIII/IX (CT9A) | 5x114.3 | 67.1 mm |
| 2008–2015 Mitsubishi Lancer Evolution | X | 5x114.3 | 67.1 mm |