2014–2017 Chevrolet SS Wheel & Tire Fitment Guide
VF (Zeta) generation, Base. 5x120 bolt pattern, stock 19×8.5 ET48 on 245/40R19. Compare 3 popular upgrades or try your own size.
Specs
| Bolt pattern | 5x120 |
|---|---|
| Center bore | 66.9 mm |
| Lug thread | M14x1.5 |
| Reference trim | Base |
| Stock wheel | 19×8.5 ET48 |
| Stock tire | 245/40R19 |
| Stock overall diameter | 26.72 in |
Calculator
Starts on the stock setup. Drag the sliders or load one of the popular upgrades below.
The small mark on each slider shows the current value. Type in the box for sizes outside the slider range.
Custom vehicle measurementsOptional
Measure with your current wheels on the car and the results below show how much room the new setup leaves. The drawings use your numbers too. Leave blank anything you haven't measured.
- Park on level ground at normal ride height, wheels straight.
- Front and rear differ. Measure the axle you're changing, or enter the tighter corner.
Millimetres or centimetres are recommended: small gaps are easier to read accurately than inch marks.
Narrowest gap between the inside of the tire (or wheel, whichever sits further in) and the strut, spring perch or upper control arm. Wheels pointed straight.
Hang a plumb line or hold a straightedge vertically from the fender lip above the hub, then measure across to the outermost point of the tire or wheel. Enter a negative number if it already sticks out.
Straight up from the top of the tire to the fender lip, with the car on the ground at normal ride height.
Smallest gap between the outer edge of the brake caliper and the inside of the wheel barrel.
- Poke
- 0mm
- Wheel face stays where it is.
- Inner clearance
- 0mm
- Same room to the suspension.
- Overall diameter
- 0%
- 0 in, within ±3%.
- Speedo reads 60
- 60mph
- Your actual speed.
| Vehicle | Chevrolet SS Base | ||
|---|---|---|---|
| Bolt pattern | 5x120 | Hub bore | 66.9 mm |
| Current | 19×8.5 ET48, 245/40R19 | New | 19×8.5 ET48, 245/40R19 |
Popular upgrades
Each size compared with the stock 19×8.5 ET48, 245/40R19.
| Setup | Poke | Inner clearance | Diameter | Speedo reads 60 | Action |
|---|---|---|---|---|---|
| Square 19×9.519×9.5 ET35, 265/35R19 | +25.7 mm | +0.3 mm | −1.5% | 59.1 mph | |
| Wide square 19×9.519×9.5 ET33, 275/35R19 | +27.7 mm | +2.3 mm | −0.5% | 59.7 mph | |
| Staggered 20×920×9 ET35, 255/35R20 | +19.4 mm | +6.6 mm | +1.2% | 60.7 mph |
Notes
- Staggered from the factory. Rear stock: 19×9 ET57 with 275/35ZR19.
- All US SS sedans got 19s; the 2014–15 polished wheels and the 2016–17 grey-machined wheels are the same 19×8.5 front and 19×9 rear sizes.
- Square 19×9.5 ET35 with 265/35R19 is a direct fit; 275/35R19 up front on 19×9.5 ET33 needed 3 mm front spacers and about -1.5° camber.
- Common 20 in staggered setups run 20×9 +35 (255/35R20) front with 20×10.5 +45 (285–295/30R20) rear.
Questions
What bolt pattern does a 2014–2017 Chevrolet SS use?
The 2014–2017 Chevrolet SS uses a 5x120 bolt pattern with a 66.9 mm center bore and M14x1.5 lug threads.
What size wheels and tires are stock on the 2014–2017 Chevrolet SS Base?
The 2014–2017 Chevrolet SS Base came with 19×8.5 ET48 wheels and 245/40R19 tires, about 26.7 inches in overall diameter.
How far does a 19×9.5 ET33 wheel stick out on a 2014–2017 Chevrolet SS?
On the 2014–2017 Chevrolet SS, compared with the stock 19×8.5 ET48, a 19×9.5 ET33 sits 27.7 mm further out at the outer lip and 2.3 mm further from the suspension at the inner barrel.
Which 2014–2017 Chevrolet SS wheel and tire upgrade keeps the speedometer most accurate?
Of the 2014–2017 Chevrolet SS upgrades listed here, 19×9.5 ET33 · 275/35R19 is closest to the stock 245/40R19, changing overall diameter by −0.5%. At an indicated 60 mph you would actually be doing 59.7 mph.
Do aftermarket wheels need hub-centric rings on a 2014–2017 Chevrolet SS?
The 2014–2017 Chevrolet SS's hub bore is 66.9 mm. Wheels machined to exactly 66.9 mm center on the hub directly; wheels with a larger bore need 66.9 mm hub-centric rings to avoid vibration.
Also on 5x120
These share the bolt pattern. Check offset, hub bore and brake clearance before swapping wheels.
| Vehicle | Generation | Bolt pattern | Hub bore |
|---|---|---|---|
| 2010–2015 Chevrolet Camaro | 5th gen | 5x120 | 66.9 mm |
| 2016–2024 Chevrolet Camaro | 6th gen | 5x120 | 66.9 mm |
| 2017–2024 Chevrolet Camaro | 6th gen | 5x120 | 66.9 mm |
| 2020+ Chevrolet Corvette | C8 | 5x120 | 66.9 mm |
| 2022+ Cadillac CT5-V Blackwing | 1st gen | 5x120 | 66.9 mm |
| 2024+ Acura Integra | DE5 | 5x120 | 64.1 mm |