2010–2015 Chevrolet Camaro Wheel & Tire Fitment Guide
5th gen generation, SS. 5x120 bolt pattern, stock 20×8 ET35 on 245/45R20. Compare 2 popular upgrades or try your own size.
Specs
| Bolt pattern | 5x120 |
|---|---|
| Center bore | 66.9 mm |
| Lug thread | M14x1.5 |
| Reference trim | SS |
| Stock wheel | 20×8 ET35 |
| Stock tire | 245/45R20 |
| Stock overall diameter | 28.68 in |
Calculator
Starts on the stock setup. Drag the sliders or load one of the popular upgrades below.
The small mark on each slider shows the current value. Type in the box for sizes outside the slider range.
Custom vehicle measurementsOptional
Measure with your current wheels on the car and the results below show how much room the new setup leaves. The drawings use your numbers too. Leave blank anything you haven't measured.
- Park on level ground at normal ride height, wheels straight.
- Front and rear differ. Measure the axle you're changing, or enter the tighter corner.
Millimetres or centimetres are recommended: small gaps are easier to read accurately than inch marks.
Narrowest gap between the inside of the tire (or wheel, whichever sits further in) and the strut, spring perch or upper control arm. Wheels pointed straight.
Hang a plumb line or hold a straightedge vertically from the fender lip above the hub, then measure across to the outermost point of the tire or wheel. Enter a negative number if it already sticks out.
Straight up from the top of the tire to the fender lip, with the car on the ground at normal ride height.
Smallest gap between the outer edge of the brake caliper and the inside of the wheel barrel.
- Poke
- 0mm
- Wheel face stays where it is.
- Inner clearance
- 0mm
- Same room to the suspension.
- Overall diameter
- 0%
- 0 in, within ±3%.
- Speedo reads 60
- 60mph
- Your actual speed.
| Vehicle | Chevrolet Camaro SS | ||
|---|---|---|---|
| Bolt pattern | 5x120 | Hub bore | 66.9 mm |
| Current | 20×8 ET35, 245/45R20 | New | 20×8 ET35, 245/45R20 |
Popular upgrades
Each size compared with the stock 20×8 ET35, 245/45R20.
| Setup | Poke | Inner clearance | Diameter | Speedo reads 60 | Action |
|---|---|---|---|---|---|
| Square 20×920×9 ET35, 255/40R20 | +12.7 mm | −12.7 mm | −2.3% | 58.6 mph | |
| ZL1-style 20×1020×10 ET23, 285/35R20 | +37.4 mm | −13.4 mm | −2.9% | 58.3 mph |
Notes
- Rear stock: 20×9 ET40 with 275/40R20.
- The ZL1's 20×10 ET23 front / 20×11 ET43 rear wheels (285/35R20 / 305/35R20) bolt on to SS cars, and aftermarket 20×10 ET23 wheels are sold to fit LS, LT and SS.
- All trims share 5x120, a 66.9 mm hub bore and M14x1.5 lug nuts, so V6 wheels bolt on but should be checked for clearance over the SS's Brembo calipers.
Questions
What bolt pattern does a 2010–2015 Chevrolet Camaro use?
The 2010–2015 Chevrolet Camaro uses a 5x120 bolt pattern with a 66.9 mm center bore and M14x1.5 lug threads.
What size wheels and tires are stock on the 2010–2015 Chevrolet Camaro SS?
The 2010–2015 Chevrolet Camaro SS came with 20×8 ET35 wheels and 245/45R20 tires, about 28.7 inches in overall diameter.
How far does a 20×10 ET23 wheel stick out on a 2010–2015 Chevrolet Camaro?
On the 2010–2015 Chevrolet Camaro, compared with the stock 20×8 ET35, a 20×10 ET23 sits 37.4 mm further out at the outer lip and 13.4 mm closer to the suspension at the inner barrel.
Which 2010–2015 Chevrolet Camaro wheel and tire upgrade keeps the speedometer most accurate?
Of the 2010–2015 Chevrolet Camaro upgrades listed here, 20×9 ET35 · 255/40R20 is closest to the stock 245/45R20, changing overall diameter by −2.3%. At an indicated 60 mph you would actually be doing 58.6 mph.
Do aftermarket wheels need hub-centric rings on a 2010–2015 Chevrolet Camaro?
The 2010–2015 Chevrolet Camaro's hub bore is 66.9 mm. Wheels machined to exactly 66.9 mm center on the hub directly; wheels with a larger bore need 66.9 mm hub-centric rings to avoid vibration.
Also on 5x120
These share the bolt pattern. Check offset, hub bore and brake clearance before swapping wheels.
| Vehicle | Generation | Bolt pattern | Hub bore |
|---|---|---|---|
| 2016–2024 Chevrolet Camaro | 6th gen | 5x120 | 66.9 mm |
| 2017–2024 Chevrolet Camaro | 6th gen | 5x120 | 66.9 mm |
| 2020+ Chevrolet Corvette | C8 | 5x120 | 66.9 mm |
| 2014–2017 Chevrolet SS | VF (Zeta) | 5x120 | 66.9 mm |
| 2022+ Cadillac CT5-V Blackwing | 1st gen | 5x120 | 66.9 mm |
| 2024+ Acura Integra | DE5 | 5x120 | 64.1 mm |