2022+ Cadillac CT5-V Blackwing Wheel & Tire Fitment Guide

1st gen generation, Blackwing. 5x120 bolt pattern, stock 19×10 ET20 on 275/35R19. Compare 2 popular upgrades or try your own size.

Specs

Bolt pattern5x120
Center bore66.9 mm
Lug threadM14x1.5
Reference trimBlackwing
Stock wheel19×10 ET20
Stock tire275/35R19
Stock overall diameter26.58 in

Calculator

Starts on the stock setup. Drag the sliders or load one of the popular upgrades below.

Wheel
in
in
mm
Tire
mm
%

The small mark on each slider shows the current value. Type in the box for sizes outside the slider range.

Custom vehicle measurementsOptional

Measure with your current wheels on the car and the results below show how much room the new setup leaves. The drawings use your numbers too. Leave blank anything you haven't measured.

  • Park on level ground at normal ride height, wheels straight.
  • Front and rear differ. Measure the axle you're changing, or enter the tighter corner.
ABCD

Millimetres or centimetres are recommended: small gaps are easier to read accurately than inch marks.

mm

Narrowest gap between the inside of the tire (or wheel, whichever sits further in) and the strut, spring perch or upper control arm. Wheels pointed straight.

mm

Hang a plumb line or hold a straightedge vertically from the fender lip above the hub, then measure across to the outermost point of the tire or wheel. Enter a negative number if it already sticks out.

mm

Straight up from the top of the tire to the fender lip, with the car on the ground at normal ride height.

mm

Smallest gap between the outer edge of the brake caliper and the inside of the wheel barrel.

Front section
StrutBrakeFender147Backspacing107Frontspacing
Three-quarter view
275/35R19
New setupCurrent setupFender and strut are drawn 12 mm outside and 28 mm inside your current setup. Add your own measurements for real clearance.
Poke
0mm
Wheel face stays where it is.
Inner clearance
0mm
Same room to the suspension.
Overall diameter
0%
0 in, within ±3%.
Speedo reads 60
60mph
Your actual speed.
VehicleCadillac CT5-V Blackwing Blackwing
Bolt pattern5x120Hub bore66.9 mm
Current19×10 ET20, 275/35R19New19×10 ET20, 275/35R19

Notes

Questions

What bolt pattern does a 2022+ Cadillac CT5-V Blackwing use?

The 2022+ Cadillac CT5-V Blackwing uses a 5x120 bolt pattern with a 66.9 mm center bore and M14x1.5 lug threads.

What size wheels and tires are stock on the 2022+ Cadillac CT5-V Blackwing Blackwing?

The 2022+ Cadillac CT5-V Blackwing Blackwing came with 19×10 ET20 wheels and 275/35R19 tires, about 26.6 inches in overall diameter.

How far does a 20×10.5 ET15 wheel stick out on a 2022+ Cadillac CT5-V Blackwing?

On the 2022+ Cadillac CT5-V Blackwing, compared with the stock 19×10 ET20, a 20×10.5 ET15 sits 11.3 mm further out at the outer lip and 1.3 mm closer to the suspension at the inner barrel.

Which 2022+ Cadillac CT5-V Blackwing wheel and tire upgrade keeps the speedometer most accurate?

Of the 2022+ Cadillac CT5-V Blackwing upgrades listed here, 19×10 ET20 · 275/35R19 is closest to the stock 275/35R19, changing overall diameter by 0%. At an indicated 60 mph you would actually be doing 60 mph.

Do aftermarket wheels need hub-centric rings on a 2022+ Cadillac CT5-V Blackwing?

The 2022+ Cadillac CT5-V Blackwing's hub bore is 66.9 mm. Wheels machined to exactly 66.9 mm center on the hub directly; wheels with a larger bore need 66.9 mm hub-centric rings to avoid vibration.

Also on 5x120

These share the bolt pattern. Check offset, hub bore and brake clearance before swapping wheels.

VehicleGenerationBolt patternHub bore
2010–2015 Chevrolet Camaro5th gen5x12066.9 mm
2016–2024 Chevrolet Camaro6th gen5x12066.9 mm
2017–2024 Chevrolet Camaro6th gen5x12066.9 mm
2020+ Chevrolet CorvetteC85x12066.9 mm
2014–2017 Chevrolet SSVF (Zeta)5x12066.9 mm
2024+ Acura IntegraDE55x12064.1 mm