2003–2008 Nissan 350Z Wheel & Tire Fitment Guide
Z33 generation, Track. 5x114.3 bolt pattern, stock 18×8 ET30 on 225/45R18. Compare 3 popular upgrades or try your own size.
Specs
| Bolt pattern | 5x114.3 |
|---|---|
| Center bore | 66.1 mm |
| Lug thread | M12x1.25 |
| Reference trim | Track |
| Stock wheel | 18×8 ET30 |
| Stock tire | 225/45R18 |
| Stock overall diameter | 25.97 in |
Calculator
Starts on the stock setup. Drag the sliders or load one of the popular upgrades below.
The small mark on each slider shows the current value. Type in the box for sizes outside the slider range.
Custom vehicle measurementsOptional
Measure with your current wheels on the car and the results below show how much room the new setup leaves. The drawings use your numbers too. Leave blank anything you haven't measured.
- Park on level ground at normal ride height, wheels straight.
- Front and rear differ. Measure the axle you're changing, or enter the tighter corner.
Millimetres or centimetres are recommended: small gaps are easier to read accurately than inch marks.
Narrowest gap between the inside of the tire (or wheel, whichever sits further in) and the strut, spring perch or upper control arm. Wheels pointed straight.
Hang a plumb line or hold a straightedge vertically from the fender lip above the hub, then measure across to the outermost point of the tire or wheel. Enter a negative number if it already sticks out.
Straight up from the top of the tire to the fender lip, with the car on the ground at normal ride height.
Smallest gap between the outer edge of the brake caliper and the inside of the wheel barrel.
- Poke
- 0mm
- Wheel face stays where it is.
- Inner clearance
- 0mm
- Same room to the suspension.
- Overall diameter
- 0%
- 0 in, within ±3%.
- Speedo reads 60
- 60mph
- Your actual speed.
| Vehicle | Nissan 350Z Track | ||
|---|---|---|---|
| Bolt pattern | 5x114.3 | Hub bore | 66.1 mm |
| Current | 18×8 ET30, 225/45R18 | New | 18×8 ET30, 225/45R18 |
Popular upgrades
Each size compared with the stock 18×8 ET30, 225/45R18.
| Setup | Poke | Inner clearance | Diameter | Speedo reads 60 | Action |
|---|---|---|---|---|---|
| Street 18×9.518×9.5 ET22, 255/40R18 | +27 mm | −11 mm | +0.2% | 60.1 mph | |
| Track square 18×9.518×9.5 ET15, 275/35R18 | +34 mm | −4 mm | −1.5% | 59.1 mph | |
| Flush 19×9.519×9.5 ET15, 245/35R19 | +34 mm | −4 mm | −0.8% | 59.5 mph |
Notes
- Rear stock: 18×8.5 ET33 with 245/45R18; the Track trim's forged Rays wheels share these sizes with the 2006–2008 18-inch 350Z wheels.
- Brembo-equipped cars (Track and other Brembo trims) need 18-inch or larger wheels, and some spoke designs still need clearance checks.
- Owners report 18×9.5 ET15 with 275/35R18 fits without fender rolling, while 18×10.5 widths usually need a slight rear fender roll.
- Uses lug nuts, and the bolt pattern and hub match the G35 Coupe, so wheels swap directly between the two cars.
Questions
What bolt pattern does a 2003–2008 Nissan 350Z use?
The 2003–2008 Nissan 350Z uses a 5x114.3 bolt pattern with a 66.1 mm center bore and M12x1.25 lug threads.
What size wheels and tires are stock on the 2003–2008 Nissan 350Z Track?
The 2003–2008 Nissan 350Z Track came with 18×8 ET30 wheels and 225/45R18 tires, about 26 inches in overall diameter.
How far does a 18×9.5 ET15 wheel stick out on a 2003–2008 Nissan 350Z?
On the 2003–2008 Nissan 350Z, compared with the stock 18×8 ET30, a 18×9.5 ET15 sits 34 mm further out at the outer lip and 4 mm closer to the suspension at the inner barrel.
Which 2003–2008 Nissan 350Z wheel and tire upgrade keeps the speedometer most accurate?
Of the 2003–2008 Nissan 350Z upgrades listed here, 18×9.5 ET22 · 255/40R18 is closest to the stock 225/45R18, changing overall diameter by +0.2%. At an indicated 60 mph you would actually be doing 60.1 mph.
Do aftermarket wheels need hub-centric rings on a 2003–2008 Nissan 350Z?
The 2003–2008 Nissan 350Z's hub bore is 66.1 mm. Wheels machined to exactly 66.1 mm center on the hub directly; wheels with a larger bore need 66.1 mm hub-centric rings to avoid vibration.
Also on 5x114.3
These share the bolt pattern. Check offset, hub bore and brake clearance before swapping wheels.
| Vehicle | Generation | Bolt pattern | Hub bore |
|---|---|---|---|
| 2009–2020 Nissan 370Z | Z34 | 5x114.3 | 66.1 mm |
| 2009–2024 Nissan GT-R | R35 | 5x114.3 | 66.1 mm |
| 2008–2013 Infiniti G37 Coupe | V36 | 5x114.3 | 66.1 mm |
| 2016–2024 Infiniti Q50 | V37 | 5x114.3 | 66.1 mm |
| 2015–2021 Subaru WRX | VA | 5x114.3 | 56.1 mm |
| 2022+ Subaru WRX | VB | 5x114.3 | 56.1 mm |