2016–2024 Infiniti Q50 Wheel & Tire Fitment Guide
V37 generation, Red Sport 400. 5x114.3 bolt pattern, stock 19×9 ET47 on 245/40R19. Compare 3 popular upgrades or try your own size.
Specs
| Bolt pattern | 5x114.3 |
|---|---|
| Center bore | 66.1 mm |
| Lug thread | M12x1.25 |
| Reference trim | Red Sport 400 |
| Stock wheel | 19×9 ET47 |
| Stock tire | 245/40R19 |
| Stock overall diameter | 26.72 in |
Calculator
Starts on the stock setup. Drag the sliders or load one of the popular upgrades below.
The small mark on each slider shows the current value. Type in the box for sizes outside the slider range.
Custom vehicle measurementsOptional
Measure with your current wheels on the car and the results below show how much room the new setup leaves. The drawings use your numbers too. Leave blank anything you haven't measured.
- Park on level ground at normal ride height, wheels straight.
- Front and rear differ. Measure the axle you're changing, or enter the tighter corner.
Millimetres or centimetres are recommended: small gaps are easier to read accurately than inch marks.
Narrowest gap between the inside of the tire (or wheel, whichever sits further in) and the strut, spring perch or upper control arm. Wheels pointed straight.
Hang a plumb line or hold a straightedge vertically from the fender lip above the hub, then measure across to the outermost point of the tire or wheel. Enter a negative number if it already sticks out.
Straight up from the top of the tire to the fender lip, with the car on the ground at normal ride height.
Smallest gap between the outer edge of the brake caliper and the inside of the wheel barrel.
- Poke
- 0mm
- Wheel face stays where it is.
- Inner clearance
- 0mm
- Same room to the suspension.
- Overall diameter
- 0%
- 0 in, within ±3%.
- Speedo reads 60
- 60mph
- Your actual speed.
| Vehicle | Infiniti Q50 Red Sport 400 | ||
|---|---|---|---|
| Bolt pattern | 5x114.3 | Hub bore | 66.1 mm |
| Current | 19×9 ET47, 245/40R19 | New | 19×9 ET47, 245/40R19 |
Popular upgrades
Each size compared with the stock 19×9 ET47, 245/40R19.
| Setup | Poke | Inner clearance | Diameter | Speedo reads 60 | Action |
|---|---|---|---|---|---|
| Flush square 19×9.519×9.5 ET35, 255/40R19 | +18.3 mm | +5.7 mm | +1.2% | 60.7 mph | |
| 20in staggered 20×920×9 ET38, 255/35R20 | +9 mm | +9 mm | +1.2% | 60.7 mph | |
| Lowered 19×9.5 +2219×9.5 ET22, 245/40R19 | +31.3 mm | +18.7 mm | 0% | 60 mph |
Notes
- Rear stock: 19×9.5 ET50 with 265/35R19.
- The Red Sport's larger brakes can block wheels that fit base Q50s, so check caliper clearance before buying 18s.
- The 20×9 +38 front is paired with a 20×10.5 +30 rear (275/35R20) and 4 mm spacers; the +22 square setup was run on lowering springs with lightly rolled fenders.
- Shares bolt pattern, 66.1 mm bore and M12x1.25 lug nuts with the Q60 and G37.
Questions
What bolt pattern does a 2016–2024 Infiniti Q50 use?
The 2016–2024 Infiniti Q50 uses a 5x114.3 bolt pattern with a 66.1 mm center bore and M12x1.25 lug threads.
What size wheels and tires are stock on the 2016–2024 Infiniti Q50 Red Sport 400?
The 2016–2024 Infiniti Q50 Red Sport 400 came with 19×9 ET47 wheels and 245/40R19 tires, about 26.7 inches in overall diameter.
How far does a 19×9.5 ET22 wheel stick out on a 2016–2024 Infiniti Q50?
On the 2016–2024 Infiniti Q50, compared with the stock 19×9 ET47, a 19×9.5 ET22 sits 31.3 mm further out at the outer lip and 18.7 mm further from the suspension at the inner barrel.
Which 2016–2024 Infiniti Q50 wheel and tire upgrade keeps the speedometer most accurate?
Of the 2016–2024 Infiniti Q50 upgrades listed here, 19×9.5 ET22 · 245/40R19 is closest to the stock 245/40R19, changing overall diameter by 0%. At an indicated 60 mph you would actually be doing 60 mph.
Do aftermarket wheels need hub-centric rings on a 2016–2024 Infiniti Q50?
The 2016–2024 Infiniti Q50's hub bore is 66.1 mm. Wheels machined to exactly 66.1 mm center on the hub directly; wheels with a larger bore need 66.1 mm hub-centric rings to avoid vibration.
Also on 5x114.3
These share the bolt pattern. Check offset, hub bore and brake clearance before swapping wheels.
| Vehicle | Generation | Bolt pattern | Hub bore |
|---|---|---|---|
| 2008–2013 Infiniti G37 Coupe | V36 | 5x114.3 | 66.1 mm |
| 2003–2008 Nissan 350Z | Z33 | 5x114.3 | 66.1 mm |
| 2009–2020 Nissan 370Z | Z34 | 5x114.3 | 66.1 mm |
| 2009–2024 Nissan GT-R | R35 | 5x114.3 | 66.1 mm |
| 2015–2021 Subaru WRX | VA | 5x114.3 | 56.1 mm |
| 2022+ Subaru WRX | VB | 5x114.3 | 56.1 mm |