2016–2023 Toyota Tacoma Wheel & Tire Fitment Guide
3rd gen generation, TRD Off-Road. 6x139.7 bolt pattern, stock 16×7 ET25 on 265/70R16. Compare 3 popular upgrades or try your own size.
Specs
| Bolt pattern | 6x139.7 |
|---|---|
| Center bore | 106.1 mm |
| Lug thread | M12x1.5 |
| Reference trim | TRD Off-Road |
| Stock wheel | 16×7 ET25 |
| Stock tire | 265/70R16 |
| Stock overall diameter | 30.61 in |
Calculator
Starts on the stock setup. Drag the sliders or load one of the popular upgrades below.
The small mark on each slider shows the current value. Type in the box for sizes outside the slider range.
Custom vehicle measurementsOptional
Measure with your current wheels on the car and the results below show how much room the new setup leaves. The drawings use your numbers too. Leave blank anything you haven't measured.
- Park on level ground at normal ride height, wheels straight.
- Front and rear differ. Measure the axle you're changing, or enter the tighter corner.
Millimetres or centimetres are recommended: small gaps are easier to read accurately than inch marks.
Narrowest gap between the inside of the tire (or wheel, whichever sits further in) and the strut, spring perch or upper control arm. Wheels pointed straight.
Hang a plumb line or hold a straightedge vertically from the fender lip above the hub, then measure across to the outermost point of the tire or wheel. Enter a negative number if it already sticks out.
Straight up from the top of the tire to the fender lip, with the car on the ground at normal ride height.
Smallest gap between the outer edge of the brake caliper and the inside of the wheel barrel.
- Poke
- 0mm
- Wheel face stays where it is.
- Inner clearance
- 0mm
- Same room to the suspension.
- Overall diameter
- 0%
- 0 in, within ±3%.
- Speedo reads 60
- 60mph
- Your actual speed.
| Vehicle | Toyota Tacoma TRD Off-Road | ||
|---|---|---|---|
| Bolt pattern | 6x139.7 | Hub bore | 106.1 mm |
| Current | 16×7 ET25, 265/70R16 | New | 16×7 ET25, 265/70R16 |
Popular upgrades
Each size compared with the stock 16×7 ET25, 265/70R16.
| Setup | Poke | Inner clearance | Diameter | Speedo reads 60 | Action |
|---|---|---|---|---|---|
| Stock wheel, 265/75R1616×7 ET25, 265/75R16 | 0 mm | 0 mm | +3.4% | 62 mph | |
| Skinny 33 on stock wheel16×7 ET25, 255/85R16 | 0 mm | 0 mm | +8% | 64.8 mph | |
| Lifted 17×8.5 ET017×8.5 ET0, 285/70R17 | +44 mm | +6 mm | +6.9% | 64.1 mph |
Notes
- 265/75R16 fits with no rubbing; 285/75R16 rubs without upper control arms, bumper trimming and a cab mount chop.
- 255/85R16 (a narrow 33-inch) is reported to fit on stock suspension.
- 285/70R17 on 0-offset wheels generally needs a 2–3 inch lift, and owners report rubbing at full lock (fixed with a cab mount chop) and possible upper control arm contact.
- Other trims: TRD Pro 16×7 ET13, TRD Sport 17×7.5 ET30; SR/SR5 run 245/75R16.
Questions
What bolt pattern does a 2016–2023 Toyota Tacoma use?
The 2016–2023 Toyota Tacoma uses a 6x139.7 bolt pattern with a 106.1 mm center bore and M12x1.5 lug threads.
What size wheels and tires are stock on the 2016–2023 Toyota Tacoma TRD Off-Road?
The 2016–2023 Toyota Tacoma TRD Off-Road came with 16×7 ET25 wheels and 265/70R16 tires, about 30.6 inches in overall diameter.
How far does a 17×8.5 ET0 wheel stick out on a 2016–2023 Toyota Tacoma?
On the 2016–2023 Toyota Tacoma, compared with the stock 16×7 ET25, a 17×8.5 ET0 sits 44 mm further out at the outer lip and 6 mm further from the suspension at the inner barrel.
Which 2016–2023 Toyota Tacoma wheel and tire upgrade keeps the speedometer most accurate?
Of the 2016–2023 Toyota Tacoma upgrades listed here, 16×7 ET25 · 265/75R16 is closest to the stock 265/70R16, changing overall diameter by +3.4%. At an indicated 60 mph you would actually be doing 62 mph.
Do aftermarket wheels need hub-centric rings on a 2016–2023 Toyota Tacoma?
The 2016–2023 Toyota Tacoma's hub bore is 106.1 mm. Wheels machined to exactly 106.1 mm center on the hub directly; wheels with a larger bore need 106.1 mm hub-centric rings to avoid vibration.
Also on 6x139.7
These share the bolt pattern. Check offset, hub bore and brake clearance before swapping wheels.
| Vehicle | Generation | Bolt pattern | Hub bore |
|---|---|---|---|
| 2021+ Ford Bronco | 6th gen (U725) | 6x139.7 | 93.1 mm |
| 2024+ Ford Ranger Raptor | P703 | 6x139.7 | 93.1 mm |