2021+ Ford Bronco Wheel & Tire Fitment Guide
6th gen (U725) generation, Badlands Sasquatch. 6x139.7 bolt pattern, stock 17×8.5 ET30 on 315/70R17. Compare 2 popular upgrades or try your own size.
Specs
| Bolt pattern | 6x139.7 |
|---|---|
| Center bore | 93.1 mm |
| Lug thread | M12x1.5 |
| Reference trim | Badlands Sasquatch |
| Stock wheel | 17×8.5 ET30 |
| Stock tire | 315/70R17 |
| Stock overall diameter | 34.36 in |
Calculator
Starts on the stock setup. Drag the sliders or load one of the popular upgrades below.
The small mark on each slider shows the current value. Type in the box for sizes outside the slider range.
Custom vehicle measurementsOptional
Measure with your current wheels on the car and the results below show how much room the new setup leaves. The drawings use your numbers too. Leave blank anything you haven't measured.
- Park on level ground at normal ride height, wheels straight.
- Front and rear differ. Measure the axle you're changing, or enter the tighter corner.
Millimetres or centimetres are recommended: small gaps are easier to read accurately than inch marks.
Narrowest gap between the inside of the tire (or wheel, whichever sits further in) and the strut, spring perch or upper control arm. Wheels pointed straight.
Hang a plumb line or hold a straightedge vertically from the fender lip above the hub, then measure across to the outermost point of the tire or wheel. Enter a negative number if it already sticks out.
Straight up from the top of the tire to the fender lip, with the car on the ground at normal ride height.
Smallest gap between the outer edge of the brake caliper and the inside of the wheel barrel.
- Poke
- 0mm
- Wheel face stays where it is.
- Inner clearance
- 0mm
- Same room to the suspension.
- Overall diameter
- 0%
- 0 in, within ±3%.
- Speedo reads 60
- 60mph
- Your actual speed.
| Vehicle | Ford Bronco Badlands Sasquatch | ||
|---|---|---|---|
| Bolt pattern | 6x139.7 | Hub bore | 93.1 mm |
| Current | 17×8.5 ET30, 315/70R17 | New | 17×8.5 ET30, 315/70R17 |
Popular upgrades
Each size compared with the stock 17×8.5 ET30, 315/70R17.
| Setup | Poke | Inner clearance | Diameter | Speedo reads 60 | Action |
|---|---|---|---|---|---|
| 17×8.5 beadlock, 35s17×8.5 ET0, 315/70R17 | +30 mm | +30 mm | 0% | 60 mph | |
| 17×9 wider stance, 35s17×9 ET1, 315/70R17 | +35.4 mm | +22.6 mm | 0% | 60 mph |
Notes
- The Sasquatch package uses 17×8.5 ET30 beadlock-capable wheels with LT315/70R17 tires, the metric equivalent of a 35×12.50R17.
- A Badlands without Sasquatch comes on 17×8 ET55 wheels with LT285/70R17 (33-inch) tires.
- The lug thread is M12x1.5, not the M14x1.5 used on the F-150, and the 6x139.7 pattern with 93.1 mm bore matches the Ranger.
- Lower-offset wheels (around 0 to ET1) with 35s fit on stock suspension, but some setups need the OEM crash bar removed and the fender liners trimmed.
Questions
What bolt pattern does a 2021+ Ford Bronco use?
The 2021+ Ford Bronco uses a 6x139.7 bolt pattern with a 93.1 mm center bore and M12x1.5 lug threads.
What size wheels and tires are stock on the 2021+ Ford Bronco Badlands Sasquatch?
The 2021+ Ford Bronco Badlands Sasquatch came with 17×8.5 ET30 wheels and 315/70R17 tires, about 34.4 inches in overall diameter.
How far does a 17×9 ET1 wheel stick out on a 2021+ Ford Bronco?
On the 2021+ Ford Bronco, compared with the stock 17×8.5 ET30, a 17×9 ET1 sits 35.4 mm further out at the outer lip and 22.6 mm further from the suspension at the inner barrel.
Which 2021+ Ford Bronco wheel and tire upgrade keeps the speedometer most accurate?
Of the 2021+ Ford Bronco upgrades listed here, 17×8.5 ET0 · 315/70R17 is closest to the stock 315/70R17, changing overall diameter by 0%. At an indicated 60 mph you would actually be doing 60 mph.
Do aftermarket wheels need hub-centric rings on a 2021+ Ford Bronco?
The 2021+ Ford Bronco's hub bore is 93.1 mm. Wheels machined to exactly 93.1 mm center on the hub directly; wheels with a larger bore need 93.1 mm hub-centric rings to avoid vibration.
Also on 6x139.7
These share the bolt pattern. Check offset, hub bore and brake clearance before swapping wheels.
| Vehicle | Generation | Bolt pattern | Hub bore |
|---|---|---|---|
| 2024+ Ford Ranger Raptor | P703 | 6x139.7 | 93.1 mm |
| 2016–2023 Toyota Tacoma | 3rd gen | 6x139.7 | 106.1 mm |