1993–1998 Toyota Supra Wheel & Tire Fitment Guide
A80 (MK4) generation, Turbo. 5x114.3 bolt pattern, stock 17×8 ET50 on 235/45R17. Compare 3 popular upgrades or try your own size.
Specs
| Bolt pattern | 5x114.3 |
|---|---|
| Center bore | 60.1 mm |
| Lug thread | M12x1.5 |
| Reference trim | Turbo |
| Stock wheel | 17×8 ET50 |
| Stock tire | 235/45R17 |
| Stock overall diameter | 25.33 in |
Calculator
Starts on the stock setup. Drag the sliders or load one of the popular upgrades below.
The small mark on each slider shows the current value. Type in the box for sizes outside the slider range.
Custom vehicle measurementsOptional
Measure with your current wheels on the car and the results below show how much room the new setup leaves. The drawings use your numbers too. Leave blank anything you haven't measured.
- Park on level ground at normal ride height, wheels straight.
- Front and rear differ. Measure the axle you're changing, or enter the tighter corner.
Millimetres or centimetres are recommended: small gaps are easier to read accurately than inch marks.
Narrowest gap between the inside of the tire (or wheel, whichever sits further in) and the strut, spring perch or upper control arm. Wheels pointed straight.
Hang a plumb line or hold a straightedge vertically from the fender lip above the hub, then measure across to the outermost point of the tire or wheel. Enter a negative number if it already sticks out.
Straight up from the top of the tire to the fender lip, with the car on the ground at normal ride height.
Smallest gap between the outer edge of the brake caliper and the inside of the wheel barrel.
- Poke
- 0mm
- Wheel face stays where it is.
- Inner clearance
- 0mm
- Same room to the suspension.
- Overall diameter
- 0%
- 0 in, within ±3%.
- Speedo reads 60
- 60mph
- Your actual speed.
| Vehicle | Toyota Supra Turbo | ||
|---|---|---|---|
| Bolt pattern | 5x114.3 | Hub bore | 60.1 mm |
| Current | 17×8 ET50, 235/45R17 | New | 17×8 ET50, 235/45R17 |
Popular upgrades
Each size compared with the stock 17×8 ET50, 235/45R17.
| Setup | Poke | Inner clearance | Diameter | Speedo reads 60 | Action |
|---|---|---|---|---|---|
| Wider 17×9.517×9.5 ET35, 235/45R17 | +34 mm | −4 mm | 0% | 60 mph | |
| Mild 18×8.518×8.5 ET31, 235/40R18 | +25.3 mm | +12.7 mm | +0.3% | 60.2 mph | |
| Flush 18×918×9 ET32, 245/40R18 | +30.7 mm | +5.3 mm | +1.5% | 60.9 mph |
Notes
- Rear stock: 17×9.5 ET50 with 255/40ZR17.
- The Turbo's larger 4-piston front brakes need 17-inch wheels; 16-inch wheels from the non-turbo will not clear them.
- The owner who ran the flush 18×9 ET32 front with an 18×10 ET32 rear on 285/35R18 had to roll the arch lips to stop rubbing; an 18×8.5/18×9.5 ET31 pair on 235/40 and 265/35 was reported rub-free.
- Uses M12x1.5 lug nuts on a 60.1 mm hub.
Questions
What bolt pattern does a 1993–1998 Toyota Supra use?
The 1993–1998 Toyota Supra uses a 5x114.3 bolt pattern with a 60.1 mm center bore and M12x1.5 lug threads.
What size wheels and tires are stock on the 1993–1998 Toyota Supra Turbo?
The 1993–1998 Toyota Supra Turbo came with 17×8 ET50 wheels and 235/45R17 tires, about 25.3 inches in overall diameter.
How far does a 17×9.5 ET35 wheel stick out on a 1993–1998 Toyota Supra?
On the 1993–1998 Toyota Supra, compared with the stock 17×8 ET50, a 17×9.5 ET35 sits 34 mm further out at the outer lip and 4 mm closer to the suspension at the inner barrel.
Which 1993–1998 Toyota Supra wheel and tire upgrade keeps the speedometer most accurate?
Of the 1993–1998 Toyota Supra upgrades listed here, 17×9.5 ET35 · 235/45R17 is closest to the stock 235/45R17, changing overall diameter by 0%. At an indicated 60 mph you would actually be doing 60 mph.
Do aftermarket wheels need hub-centric rings on a 1993–1998 Toyota Supra?
The 1993–1998 Toyota Supra's hub bore is 60.1 mm. Wheels machined to exactly 60.1 mm center on the hub directly; wheels with a larger bore need 60.1 mm hub-centric rings to avoid vibration.
Also on 5x114.3
These share the bolt pattern. Check offset, hub bore and brake clearance before swapping wheels.
| Vehicle | Generation | Bolt pattern | Hub bore |
|---|---|---|---|
| 2023+ Toyota GR Corolla | E210 | 5x114.3 | 60.1 mm |
| 2002–2006 Acura RSX | DC5 | 5x114.3 | 64.1 mm |
| 2009–2014 Acura TSX | CU2 | 5x114.3 | 64.1 mm |
| 2019+ Genesis G70 | 1st gen (IK) | 5x114.3 | 67.1 mm |
| 2016–2021 Honda Civic | 10th gen (FC/FK) | 5x114.3 | 64.1 mm |
| 2022+ Honda Civic | 11th gen (FE) | 5x114.3 | 64.1 mm |