2022+ Honda Civic Wheel & Tire Fitment Guide

11th gen (FE) generation, Si. 5x114.3 bolt pattern, stock 18×8 ET50 on 235/40R18. Compare 3 popular upgrades or try your own size.

Specs

Bolt pattern5x114.3
Center bore64.1 mm
Lug threadM12x1.5
Reference trimSi
Stock wheel18×8 ET50
Stock tire235/40R18
Stock overall diameter25.4 in

Calculator

Starts on the stock setup. Drag the sliders or load one of the popular upgrades below.

Wheel
in
in
mm
Tire
mm
%

The small mark on each slider shows the current value. Type in the box for sizes outside the slider range.

Custom vehicle measurementsOptional

Measure with your current wheels on the car and the results below show how much room the new setup leaves. The drawings use your numbers too. Leave blank anything you haven't measured.

  • Park on level ground at normal ride height, wheels straight.
  • Front and rear differ. Measure the axle you're changing, or enter the tighter corner.
ABCD

Millimetres or centimetres are recommended: small gaps are easier to read accurately than inch marks.

mm

Narrowest gap between the inside of the tire (or wheel, whichever sits further in) and the strut, spring perch or upper control arm. Wheels pointed straight.

mm

Hang a plumb line or hold a straightedge vertically from the fender lip above the hub, then measure across to the outermost point of the tire or wheel. Enter a negative number if it already sticks out.

mm

Straight up from the top of the tire to the fender lip, with the car on the ground at normal ride height.

mm

Smallest gap between the outer edge of the brake caliper and the inside of the wheel barrel.

Front section
StrutBrakeFender151.6Backspacing51.6 Frontspacing
Three-quarter view
235/40R18
New setupCurrent setupFender and strut are drawn 12 mm outside and 28 mm inside your current setup. Add your own measurements for real clearance.
Poke
0mm
Wheel face stays where it is.
Inner clearance
0mm
Same room to the suspension.
Overall diameter
0%
0 in, within ±3%.
Speedo reads 60
60mph
Your actual speed.
VehicleHonda Civic Si
Bolt pattern5x114.3Hub bore64.1 mm
Current18×8 ET50, 235/40R18New18×8 ET50, 235/40R18

Notes

Questions

What bolt pattern does a 2022+ Honda Civic use?

The 2022+ Honda Civic uses a 5x114.3 bolt pattern with a 64.1 mm center bore and M12x1.5 lug threads.

What size wheels and tires are stock on the 2022+ Honda Civic Si?

The 2022+ Honda Civic Si came with 18×8 ET50 wheels and 235/40R18 tires, about 25.4 inches in overall diameter.

How far does a 18×9.5 ET40 wheel stick out on a 2022+ Honda Civic?

On the 2022+ Honda Civic, compared with the stock 18×8 ET50, a 18×9.5 ET40 sits 29 mm further out at the outer lip and 9 mm closer to the suspension at the inner barrel.

Which 2022+ Honda Civic wheel and tire upgrade keeps the speedometer most accurate?

Of the 2022+ Honda Civic upgrades listed here, 18×8.5 ET45 · 235/40R18 is closest to the stock 235/40R18, changing overall diameter by 0%. At an indicated 60 mph you would actually be doing 60 mph.

Do aftermarket wheels need hub-centric rings on a 2022+ Honda Civic?

The 2022+ Honda Civic's hub bore is 64.1 mm. Wheels machined to exactly 64.1 mm center on the hub directly; wheels with a larger bore need 64.1 mm hub-centric rings to avoid vibration.

Also on 5x114.3

These share the bolt pattern. Check offset, hub bore and brake clearance before swapping wheels.

VehicleGenerationBolt patternHub bore
2016–2021 Honda Civic10th gen (FC/FK)5x114.364.1 mm
2002–2006 Acura RSXDC55x114.364.1 mm
2009–2014 Acura TSXCU25x114.364.1 mm
2000–2009 Honda S2000AP1/AP25x114.370.1 mm
2017–2023 Tesla Model 3Gen 15x114.364.1 mm
2019+ Genesis G701st gen (IK)5x114.367.1 mm