2018+ Jeep Wrangler Wheel & Tire Fitment Guide
JL generation, Sport. 5x127 bolt pattern, stock 17×7.5 ET44.45 on 245/75R17. Compare 2 popular upgrades or try your own size.
Specs
| Bolt pattern | 5x127 |
|---|---|
| Center bore | 71.5 mm |
| Lug thread | M14x1.5 |
| Reference trim | Sport |
| Stock wheel | 17×7.5 ET44.45 |
| Stock tire | 245/75R17 |
| Stock overall diameter | 31.47 in |
Calculator
Starts on the stock setup. Drag the sliders or load one of the popular upgrades below.
The small mark on each slider shows the current value. Type in the box for sizes outside the slider range.
Custom vehicle measurementsOptional
Measure with your current wheels on the car and the results below show how much room the new setup leaves. The drawings use your numbers too. Leave blank anything you haven't measured.
- Park on level ground at normal ride height, wheels straight.
- Front and rear differ. Measure the axle you're changing, or enter the tighter corner.
Millimetres or centimetres are recommended: small gaps are easier to read accurately than inch marks.
Narrowest gap between the inside of the tire (or wheel, whichever sits further in) and the strut, spring perch or upper control arm. Wheels pointed straight.
Hang a plumb line or hold a straightedge vertically from the fender lip above the hub, then measure across to the outermost point of the tire or wheel. Enter a negative number if it already sticks out.
Straight up from the top of the tire to the fender lip, with the car on the ground at normal ride height.
Smallest gap between the outer edge of the brake caliper and the inside of the wheel barrel.
- Poke
- 0mm
- Wheel face stays where it is.
- Inner clearance
- 0mm
- Same room to the suspension.
- Overall diameter
- 0%
- 0 in, within ±3%.
- Speedo reads 60
- 60mph
- Your actual speed.
| Vehicle | Jeep Wrangler Sport | ||
|---|---|---|---|
| Bolt pattern | 5x127 | Hub bore | 71.5 mm |
| Current | 17×7.5 ET44.45, 245/75R17 | New | 17×7.5 ET44.45, 245/75R17 |
Popular upgrades
Each size compared with the stock 17×7.5 ET44.45, 245/75R17.
| Setup | Poke | Inner clearance | Diameter | Speedo reads 60 | Action |
|---|---|---|---|---|---|
| 33s on Rubicon takeoffs17×7.5 ET44.45, 285/70R17 | 0 mm | 0 mm | +3.9% | 62.4 mph | |
| 35s on 2.5in lift, 17×917×9 ET-12, 315/70R17 | +75.5 mm | +37.4 mm | +9.2% | 65.5 mph |
Notes
- 5x127 is the same as 5x5 in. JL lug nuts are M14×1.5 with a 22 mm hex, while JK uses 1/2-20 studs. Wheels interchange with the Gladiator, but JK lug nuts will not seat on JL wheels.
- The Rubicon size (285/70R17, about 33 in) on factory 17×7.5 +44.45 wheels generally clears a stock Sport on the street. Expect some rubbing at full flex off-road.
- Sport fenders sit lower than the Rubicon's high-clearance fenders. 35s (roughly 315/70R17) usually need a 2–2.5 in lift plus bump-stop extensions, and they can still rub at full articulation.
- Any diameter change over about 3% should be followed by a speedometer recalibration with a dealer tool or programmer.
Questions
What bolt pattern does a 2018+ Jeep Wrangler use?
The 2018+ Jeep Wrangler uses a 5x127 bolt pattern with a 71.5 mm center bore and M14x1.5 lug threads.
What size wheels and tires are stock on the 2018+ Jeep Wrangler Sport?
The 2018+ Jeep Wrangler Sport came with 17×7.5 ET44.45 wheels and 245/75R17 tires, about 31.5 inches in overall diameter.
How far does a 17×9 ET-12 wheel stick out on a 2018+ Jeep Wrangler?
On the 2018+ Jeep Wrangler, compared with the stock 17×7.5 ET44.45, a 17×9 ET-12 sits 75.5 mm further out at the outer lip and 37.4 mm further from the suspension at the inner barrel.
Which 2018+ Jeep Wrangler wheel and tire upgrade keeps the speedometer most accurate?
Of the 2018+ Jeep Wrangler upgrades listed here, 17×7.5 ET44.45 · 285/70R17 is closest to the stock 245/75R17, changing overall diameter by +3.9%. At an indicated 60 mph you would actually be doing 62.4 mph.
Do aftermarket wheels need hub-centric rings on a 2018+ Jeep Wrangler?
The 2018+ Jeep Wrangler's hub bore is 71.5 mm. Wheels machined to exactly 71.5 mm center on the hub directly; wheels with a larger bore need 71.5 mm hub-centric rings to avoid vibration.
Also on 5x127
These share the bolt pattern. Check offset, hub bore and brake clearance before swapping wheels.
| Vehicle | Generation | Bolt pattern | Hub bore |
|---|---|---|---|
| 2020+ Jeep Gladiator | JT | 5x127 | 71.5 mm |
| 2007–2018 Jeep Wrangler | JK | 5x127 | 71.5 mm |