2015–2017 Ford Mustang Wheel & Tire Fitment Guide
S550 generation, GT Performance Pack. 5x114.3 bolt pattern, stock 19×9 ET45 on 255/40R19. Compare 3 popular upgrades or try your own size.
Specs
| Bolt pattern | 5x114.3 |
|---|---|
| Center bore | 70.5 mm |
| Lug thread | M14x1.5 |
| Reference trim | GT Performance Pack |
| Stock wheel | 19×9 ET45 |
| Stock tire | 255/40R19 |
| Stock overall diameter | 27.03 in |
Calculator
Starts on the stock setup. Drag the sliders or load one of the popular upgrades below.
The small mark on each slider shows the current value. Type in the box for sizes outside the slider range.
Custom vehicle measurementsOptional
Measure with your current wheels on the car and the results below show how much room the new setup leaves. The drawings use your numbers too. Leave blank anything you haven't measured.
- Park on level ground at normal ride height, wheels straight.
- Front and rear differ. Measure the axle you're changing, or enter the tighter corner.
Millimetres or centimetres are recommended: small gaps are easier to read accurately than inch marks.
Narrowest gap between the inside of the tire (or wheel, whichever sits further in) and the strut, spring perch or upper control arm. Wheels pointed straight.
Hang a plumb line or hold a straightedge vertically from the fender lip above the hub, then measure across to the outermost point of the tire or wheel. Enter a negative number if it already sticks out.
Straight up from the top of the tire to the fender lip, with the car on the ground at normal ride height.
Smallest gap between the outer edge of the brake caliper and the inside of the wheel barrel.
- Poke
- 0mm
- Wheel face stays where it is.
- Inner clearance
- 0mm
- Same room to the suspension.
- Overall diameter
- 0%
- 0 in, within ±3%.
- Speedo reads 60
- 60mph
- Your actual speed.
| Vehicle | Ford Mustang GT Performance Pack | ||
|---|---|---|---|
| Bolt pattern | 5x114.3 | Hub bore | 70.5 mm |
| Current | 19×9 ET45, 255/40R19 | New | 19×9 ET45, 255/40R19 |
Popular upgrades
Each size compared with the stock 19×9 ET45, 255/40R19.
| Setup | Poke | Inner clearance | Diameter | Speedo reads 60 | Action |
|---|---|---|---|---|---|
| Square 19×9.5 ET3519×9.5 ET35, 285/35R19 | +16.3 mm | +3.7 mm | −0.7% | 59.6 mph | |
| Square 19×10 ET4019×10 ET40, 285/35R19 | +17.7 mm | −7.7 mm | −0.7% | 59.6 mph | |
| Flush square 19×10 ET3519×10 ET35, 285/35R19 | +22.7 mm | −2.7 mm | −0.7% | 59.6 mph |
Notes
- Rear stock: 19×9.5 ET52.5 with 275/40R19.
- The Performance Pack's 6-piston Brembo front calipers on 15-inch rotors require 19-inch or larger wheels.
- The factory 19×9.5 ET52.5 PP wheel is rear-only; a 19×10 ET35-40 with 285/35R19 is the common rotatable square setup with no spacers.
- Lug nuts M14x1.5 on a 70.5 mm hub; most aftermarket wheels need 70.5 mm hub rings.
Questions
What bolt pattern does a 2015–2017 Ford Mustang use?
The 2015–2017 Ford Mustang uses a 5x114.3 bolt pattern with a 70.5 mm center bore and M14x1.5 lug threads.
What size wheels and tires are stock on the 2015–2017 Ford Mustang GT Performance Pack?
The 2015–2017 Ford Mustang GT Performance Pack came with 19×9 ET45 wheels and 255/40R19 tires, about 27 inches in overall diameter.
How far does a 19×10 ET35 wheel stick out on a 2015–2017 Ford Mustang?
On the 2015–2017 Ford Mustang, compared with the stock 19×9 ET45, a 19×10 ET35 sits 22.7 mm further out at the outer lip and 2.7 mm closer to the suspension at the inner barrel.
Which 2015–2017 Ford Mustang wheel and tire upgrade keeps the speedometer most accurate?
Of the 2015–2017 Ford Mustang upgrades listed here, 19×9.5 ET35 · 285/35R19 is closest to the stock 255/40R19, changing overall diameter by −0.7%. At an indicated 60 mph you would actually be doing 59.6 mph.
Do aftermarket wheels need hub-centric rings on a 2015–2017 Ford Mustang?
The 2015–2017 Ford Mustang's hub bore is 70.5 mm. Wheels machined to exactly 70.5 mm center on the hub directly; wheels with a larger bore need 70.5 mm hub-centric rings to avoid vibration.
Also on 5x114.3
These share the bolt pattern. Check offset, hub bore and brake clearance before swapping wheels.
| Vehicle | Generation | Bolt pattern | Hub bore |
|---|---|---|---|
| 2015–2020 Ford Mustang Shelby GT350 | S550 | 5x114.3 | 70.5 mm |
| 2025+ Hyundai Ioniq 5 N | NE | 5x114.3 | 67.1 mm |
| 2017–2023 Tesla Model 3 | Gen 1 | 5x114.3 | 64.1 mm |
| 2002–2006 Acura RSX | DC5 | 5x114.3 | 64.1 mm |
| 2009–2014 Acura TSX | CU2 | 5x114.3 | 64.1 mm |
| 2019+ Genesis G70 | 1st gen (IK) | 5x114.3 | 67.1 mm |