2013–2020 Subaru BRZ Wheel & Tire Fitment Guide
ZC6 generation, Limited. 5x100 bolt pattern, stock 17×7 ET48 on 215/45R17. Compare 3 popular upgrades or try your own size.
Specs
| Bolt pattern | 5x100 |
|---|---|
| Center bore | 56.1 mm |
| Lug thread | M12x1.25 |
| Reference trim | Limited |
| Stock wheel | 17×7 ET48 |
| Stock tire | 215/45R17 |
| Stock overall diameter | 24.62 in |
Calculator
Starts on the stock setup. Drag the sliders or load one of the popular upgrades below.
The small mark on each slider shows the current value. Type in the box for sizes outside the slider range.
Custom vehicle measurementsOptional
Measure with your current wheels on the car and the results below show how much room the new setup leaves. The drawings use your numbers too. Leave blank anything you haven't measured.
- Park on level ground at normal ride height, wheels straight.
- Front and rear differ. Measure the axle you're changing, or enter the tighter corner.
Millimetres or centimetres are recommended: small gaps are easier to read accurately than inch marks.
Narrowest gap between the inside of the tire (or wheel, whichever sits further in) and the strut, spring perch or upper control arm. Wheels pointed straight.
Hang a plumb line or hold a straightedge vertically from the fender lip above the hub, then measure across to the outermost point of the tire or wheel. Enter a negative number if it already sticks out.
Straight up from the top of the tire to the fender lip, with the car on the ground at normal ride height.
Smallest gap between the outer edge of the brake caliper and the inside of the wheel barrel.
- Poke
- 0mm
- Wheel face stays where it is.
- Inner clearance
- 0mm
- Same room to the suspension.
- Overall diameter
- 0%
- 0 in, within ±3%.
- Speedo reads 60
- 60mph
- Your actual speed.
| Vehicle | Subaru BRZ Limited | ||
|---|---|---|---|
| Bolt pattern | 5x100 | Hub bore | 56.1 mm |
| Current | 17×7 ET48, 215/45R17 | New | 17×7 ET48, 215/45R17 |
Popular upgrades
Each size compared with the stock 17×7 ET48, 215/45R17.
| Setup | Poke | Inner clearance | Diameter | Speedo reads 60 | Action |
|---|---|---|---|---|---|
| OEM+ 17×817×8 ET40, 225/45R17 | +20.7 mm | −4.7 mm | +1.4% | 60.9 mph | |
| Square 17×917×9 ET40, 245/40R17 | +33.4 mm | −17.4 mm | +0.4% | 60.2 mph | |
| Flush 18×9.518×9.5 ET40, 255/35R18 | +39.8 mm | −23.8 mm | +1.7% | 61 mph |
Notes
- 2013–2016 cars use 17×7 ET48 wheels; 2017–2020 cars got a new 17×7.5 ET48 wheel. Both run 215/45R17 tires.
- 2017–2020 Performance Package cars have Brembo calipers and larger SACHS front struts, so check spoke clearance and allow for a front spacer on wide or high-offset wheels.
- An 18×9.5 ET40 needs coilovers, about -2.5° of front camber and often trimmed rear fender tabs.
- Mechanical twin of the Scion FR-S (2013–2016) and Toyota 86 (2017–2020), and shares 5x100, a 56.1 mm hub bore and M12x1.25 with the 2022+ BRZ and GR86.
Questions
What bolt pattern does a 2013–2020 Subaru BRZ use?
The 2013–2020 Subaru BRZ uses a 5x100 bolt pattern with a 56.1 mm center bore and M12x1.25 lug threads.
What size wheels and tires are stock on the 2013–2020 Subaru BRZ Limited?
The 2013–2020 Subaru BRZ Limited came with 17×7 ET48 wheels and 215/45R17 tires, about 24.6 inches in overall diameter.
How far does a 18×9.5 ET40 wheel stick out on a 2013–2020 Subaru BRZ?
On the 2013–2020 Subaru BRZ, compared with the stock 17×7 ET48, a 18×9.5 ET40 sits 39.8 mm further out at the outer lip and 23.8 mm closer to the suspension at the inner barrel.
Which 2013–2020 Subaru BRZ wheel and tire upgrade keeps the speedometer most accurate?
Of the 2013–2020 Subaru BRZ upgrades listed here, 17×9 ET40 · 245/40R17 is closest to the stock 215/45R17, changing overall diameter by +0.4%. At an indicated 60 mph you would actually be doing 60.2 mph.
Do aftermarket wheels need hub-centric rings on a 2013–2020 Subaru BRZ?
The 2013–2020 Subaru BRZ's hub bore is 56.1 mm. Wheels machined to exactly 56.1 mm center on the hub directly; wheels with a larger bore need 56.1 mm hub-centric rings to avoid vibration.
Also on 5x100
These share the bolt pattern. Check offset, hub bore and brake clearance before swapping wheels.
| Vehicle | Generation | Bolt pattern | Hub bore |
|---|---|---|---|
| 2022+ Subaru BRZ | ZD8 | 5x100 | 56.1 mm |
| 2022+ Toyota GR86 | ZN8 | 5x100 | 56.1 mm |