2013–2018 Ford Focus ST Wheel & Tire Fitment Guide
Mk3 generation, ST. 5x108 bolt pattern, stock 18×8 ET55 on 235/40R18. Compare 2 popular upgrades or try your own size.
Specs
| Bolt pattern | 5x108 |
|---|---|
| Center bore | 63.4 mm |
| Lug thread | M12x1.5 |
| Reference trim | ST |
| Stock wheel | 18×8 ET55 |
| Stock tire | 235/40R18 |
| Stock overall diameter | 25.4 in |
Calculator
Starts on the stock setup. Drag the sliders or load one of the popular upgrades below.
The small mark on each slider shows the current value. Type in the box for sizes outside the slider range.
Custom vehicle measurementsOptional
Measure with your current wheels on the car and the results below show how much room the new setup leaves. The drawings use your numbers too. Leave blank anything you haven't measured.
- Park on level ground at normal ride height, wheels straight.
- Front and rear differ. Measure the axle you're changing, or enter the tighter corner.
Millimetres or centimetres are recommended: small gaps are easier to read accurately than inch marks.
Narrowest gap between the inside of the tire (or wheel, whichever sits further in) and the strut, spring perch or upper control arm. Wheels pointed straight.
Hang a plumb line or hold a straightedge vertically from the fender lip above the hub, then measure across to the outermost point of the tire or wheel. Enter a negative number if it already sticks out.
Straight up from the top of the tire to the fender lip, with the car on the ground at normal ride height.
Smallest gap between the outer edge of the brake caliper and the inside of the wheel barrel.
- Poke
- 0mm
- Wheel face stays where it is.
- Inner clearance
- 0mm
- Same room to the suspension.
- Overall diameter
- 0%
- 0 in, within ±3%.
- Speedo reads 60
- 60mph
- Your actual speed.
| Vehicle | Ford Focus ST ST | ||
|---|---|---|---|
| Bolt pattern | 5x108 | Hub bore | 63.4 mm |
| Current | 18×8 ET55, 235/40R18 | New | 18×8 ET55, 235/40R18 |
Popular upgrades
Each size compared with the stock 18×8 ET55, 235/40R18.
| Setup | Poke | Inner clearance | Diameter | Speedo reads 60 | Action |
|---|---|---|---|---|---|
| Mild 18×8.518×8.5 ET42, 245/40R18 | +19.3 mm | +6.7 mm | +1.2% | 60.7 mph | |
| Wider 18×918×9 ET38, 245/40R18 | +29.7 mm | +4.3 mm | +1.2% | 60.7 mph |
Notes
- The stock ET55 is a lot of offset, so most aftermarket 18×8.5 wheels in the ET42–45 range sit noticeably further out without rubbing on stock or lowering springs.
- The hub bore is 63.4 mm. Aftermarket wheels with 72.6 or 73.1 mm bores need hub-centric rings. The car uses M12x1.5 lug nuts.
- The Focus ST and Focus RS share 5x108 and the 63.4 mm hub, but the RS's Brembo calipers are bigger, so a wheel that clears an ST may not clear an RS.
Questions
What bolt pattern does a 2013–2018 Ford Focus ST use?
The 2013–2018 Ford Focus ST uses a 5x108 bolt pattern with a 63.4 mm center bore and M12x1.5 lug threads.
What size wheels and tires are stock on the 2013–2018 Ford Focus ST ST?
The 2013–2018 Ford Focus ST ST came with 18×8 ET55 wheels and 235/40R18 tires, about 25.4 inches in overall diameter.
How far does a 18×9 ET38 wheel stick out on a 2013–2018 Ford Focus ST?
On the 2013–2018 Ford Focus ST, compared with the stock 18×8 ET55, a 18×9 ET38 sits 29.7 mm further out at the outer lip and 4.3 mm further from the suspension at the inner barrel.
Which 2013–2018 Ford Focus ST wheel and tire upgrade keeps the speedometer most accurate?
Of the 2013–2018 Ford Focus ST upgrades listed here, 18×8.5 ET42 · 245/40R18 is closest to the stock 235/40R18, changing overall diameter by +1.2%. At an indicated 60 mph you would actually be doing 60.7 mph.
Do aftermarket wheels need hub-centric rings on a 2013–2018 Ford Focus ST?
The 2013–2018 Ford Focus ST's hub bore is 63.4 mm. Wheels machined to exactly 63.4 mm center on the hub directly; wheels with a larger bore need 63.4 mm hub-centric rings to avoid vibration.
Also on 5x108
These share the bolt pattern. Check offset, hub bore and brake clearance before swapping wheels.
| Vehicle | Generation | Bolt pattern | Hub bore |
|---|---|---|---|
| 2016–2018 Ford Focus RS | Mk3 | 5x108 | 63.4 mm |