1999–2006 BMW 3 Series Wheel & Tire Fitment Guide

E46 generation, 330Ci Sport. 5x120 bolt pattern, stock 17×7.5 ET41 on 225/45R17. Compare 3 popular upgrades or try your own size.

Specs

Bolt pattern5x120
Center bore72.6 mm
Lug threadM12x1.5
Reference trim330Ci Sport
Stock wheel17×7.5 ET41
Stock tire225/45R17
Stock overall diameter24.97 in

Calculator

Starts on the stock setup. Drag the sliders or load one of the popular upgrades below.

Wheel
in
in
mm
Tire
mm
%

The small mark on each slider shows the current value. Type in the box for sizes outside the slider range.

Custom vehicle measurementsOptional

Measure with your current wheels on the car and the results below show how much room the new setup leaves. The drawings use your numbers too. Leave blank anything you haven't measured.

  • Park on level ground at normal ride height, wheels straight.
  • Front and rear differ. Measure the axle you're changing, or enter the tighter corner.
ABCD

Millimetres or centimetres are recommended: small gaps are easier to read accurately than inch marks.

mm

Narrowest gap between the inside of the tire (or wheel, whichever sits further in) and the strut, spring perch or upper control arm. Wheels pointed straight.

mm

Hang a plumb line or hold a straightedge vertically from the fender lip above the hub, then measure across to the outermost point of the tire or wheel. Enter a negative number if it already sticks out.

mm

Straight up from the top of the tire to the fender lip, with the car on the ground at normal ride height.

mm

Smallest gap between the outer edge of the brake caliper and the inside of the wheel barrel.

Front section
StrutBrakeFender136.3Backspacing54.3 Frontspacing
Three-quarter view
225/45R17
New setupCurrent setupFender and strut are drawn 12 mm outside and 28 mm inside your current setup. Add your own measurements for real clearance.
Poke
0mm
Wheel face stays where it is.
Inner clearance
0mm
Same room to the suspension.
Overall diameter
0%
0 in, within ±3%.
Speedo reads 60
60mph
Your actual speed.
VehicleBMW 3 Series 330Ci Sport
Bolt pattern5x120Hub bore72.6 mm
Current17×7.5 ET41, 225/45R17New17×7.5 ET41, 225/45R17

Notes

Questions

What bolt pattern does a 1999–2006 BMW 3 Series use?

The 1999–2006 BMW 3 Series uses a 5x120 bolt pattern with a 72.6 mm center bore and M12x1.5 lug threads.

What size wheels and tires are stock on the 1999–2006 BMW 3 Series 330Ci Sport?

The 1999–2006 BMW 3 Series 330Ci Sport came with 17×7.5 ET41 wheels and 225/45R17 tires, about 25 inches in overall diameter.

How far does a 18×9 ET30 wheel stick out on a 1999–2006 BMW 3 Series?

On the 1999–2006 BMW 3 Series, compared with the stock 17×7.5 ET41, a 18×9 ET30 sits 30 mm further out at the outer lip and 8.1 mm closer to the suspension at the inner barrel.

Which 1999–2006 BMW 3 Series wheel and tire upgrade keeps the speedometer most accurate?

Of the 1999–2006 BMW 3 Series upgrades listed here, 18×8 ET47 · 225/40R18 is closest to the stock 225/45R17, changing overall diameter by +0.5%. At an indicated 60 mph you would actually be doing 60.3 mph.

Do aftermarket wheels need hub-centric rings on a 1999–2006 BMW 3 Series?

The 1999–2006 BMW 3 Series's hub bore is 72.6 mm. Wheels machined to exactly 72.6 mm center on the hub directly; wheels with a larger bore need 72.6 mm hub-centric rings to avoid vibration.

Also on 5x120

These share the bolt pattern. Check offset, hub bore and brake clearance before swapping wheels.

VehicleGenerationBolt patternHub bore
1992–1999 BMW 3 SeriesE365x12072.6 mm
2001–2006 BMW M3E465x12072.6 mm
2008–2013 BMW M3E90/E925x12072.6 mm
2006–2008 BMW Z4 M RoadsterE855x12072.6 mm
2016–2021 BMW M2F875x12072.6 mm
2015–2018 BMW M3F805x12072.6 mm