2014–2019 Ford Fiesta ST Wheel & Tire Fitment Guide
Mk7 generation, ST. 4x108 bolt pattern, stock 17×7 ET47.5 on 205/40R17. Compare 2 popular upgrades or try your own size.
Specs
| Bolt pattern | 4x108 |
|---|---|
| Center bore | 63.4 mm |
| Lug thread | M12x1.5 |
| Reference trim | ST |
| Stock wheel | 17×7 ET47.5 |
| Stock tire | 205/40R17 |
| Stock overall diameter | 23.46 in |
Calculator
Starts on the stock setup. Drag the sliders or load one of the popular upgrades below.
The small mark on each slider shows the current value. Type in the box for sizes outside the slider range.
Custom vehicle measurementsOptional
Measure with your current wheels on the car and the results below show how much room the new setup leaves. The drawings use your numbers too. Leave blank anything you haven't measured.
- Park on level ground at normal ride height, wheels straight.
- Front and rear differ. Measure the axle you're changing, or enter the tighter corner.
Millimetres or centimetres are recommended: small gaps are easier to read accurately than inch marks.
Narrowest gap between the inside of the tire (or wheel, whichever sits further in) and the strut, spring perch or upper control arm. Wheels pointed straight.
Hang a plumb line or hold a straightedge vertically from the fender lip above the hub, then measure across to the outermost point of the tire or wheel. Enter a negative number if it already sticks out.
Straight up from the top of the tire to the fender lip, with the car on the ground at normal ride height.
Smallest gap between the outer edge of the brake caliper and the inside of the wheel barrel.
- Poke
- 0mm
- Wheel face stays where it is.
- Inner clearance
- 0mm
- Same room to the suspension.
- Overall diameter
- 0%
- 0 in, within ±3%.
- Speedo reads 60
- 60mph
- Your actual speed.
| Vehicle | Ford Fiesta ST ST | ||
|---|---|---|---|
| Bolt pattern | 4x108 | Hub bore | 63.4 mm |
| Current | 17×7 ET47.5, 205/40R17 | New | 17×7 ET47.5, 205/40R17 |
Popular upgrades
Each size compared with the stock 17×7 ET47.5, 205/40R17.
| Setup | Poke | Inner clearance | Diameter | Speedo reads 60 | Action |
|---|---|---|---|---|---|
| Mild 17×7 215/4017×7 ET40, 215/40R17 | +7.5 mm | +7.5 mm | +1.3% | 60.8 mph | |
| Wide 17×817×8 ET40, 215/40R17 | +20.2 mm | −5.2 mm | +1.3% | 60.8 mph |
Notes
- 4x108 with a 63.4 mm hub is an uncommon combination, so wheel choice is limited and most aftermarket wheels need hub-centric rings. The car uses M12x1.5 lug nuts.
- A 215/40R17 on a 17×7 ET40 fits on stock suspension. 215/45R17 tires (e.g. on 17×7.5 ET45) rub the wheel liners in hard corners.
- On a 17×8, owners advise staying at about ET38 or higher. A 225/40R17 gets very close to coilover bodies and the fenders.
Questions
What bolt pattern does a 2014–2019 Ford Fiesta ST use?
The 2014–2019 Ford Fiesta ST uses a 4x108 bolt pattern with a 63.4 mm center bore and M12x1.5 lug threads.
What size wheels and tires are stock on the 2014–2019 Ford Fiesta ST ST?
The 2014–2019 Ford Fiesta ST ST came with 17×7 ET47.5 wheels and 205/40R17 tires, about 23.5 inches in overall diameter.
How far does a 17×8 ET40 wheel stick out on a 2014–2019 Ford Fiesta ST?
On the 2014–2019 Ford Fiesta ST, compared with the stock 17×7 ET47.5, a 17×8 ET40 sits 20.2 mm further out at the outer lip and 5.2 mm closer to the suspension at the inner barrel.
Which 2014–2019 Ford Fiesta ST wheel and tire upgrade keeps the speedometer most accurate?
Of the 2014–2019 Ford Fiesta ST upgrades listed here, 17×7 ET40 · 215/40R17 is closest to the stock 205/40R17, changing overall diameter by +1.3%. At an indicated 60 mph you would actually be doing 60.8 mph.
Do aftermarket wheels need hub-centric rings on a 2014–2019 Ford Fiesta ST?
The 2014–2019 Ford Fiesta ST's hub bore is 63.4 mm. Wheels machined to exactly 63.4 mm center on the hub directly; wheels with a larger bore need 63.4 mm hub-centric rings to avoid vibration.