2017–2022 Chevrolet Colorado Wheel & Tire Fitment Guide
2nd gen generation, ZR2. 6x120 bolt pattern, stock 17×8 ET33 on 265/65R17. Compare 3 popular upgrades or try your own size.
Specs
| Bolt pattern | 6x120 |
|---|---|
| Center bore | 66.9 mm |
| Lug thread | M14x1.5 |
| Reference trim | ZR2 |
| Stock wheel | 17×8 ET33 |
| Stock tire | 265/65R17 |
| Stock overall diameter | 30.56 in |
Calculator
Starts on the stock setup. Drag the sliders or load one of the popular upgrades below.
The small mark on each slider shows the current value. Type in the box for sizes outside the slider range.
Custom vehicle measurementsOptional
Measure with your current wheels on the car and the results below show how much room the new setup leaves. The drawings use your numbers too. Leave blank anything you haven't measured.
- Park on level ground at normal ride height, wheels straight.
- Front and rear differ. Measure the axle you're changing, or enter the tighter corner.
Millimetres or centimetres are recommended: small gaps are easier to read accurately than inch marks.
Narrowest gap between the inside of the tire (or wheel, whichever sits further in) and the strut, spring perch or upper control arm. Wheels pointed straight.
Hang a plumb line or hold a straightedge vertically from the fender lip above the hub, then measure across to the outermost point of the tire or wheel. Enter a negative number if it already sticks out.
Straight up from the top of the tire to the fender lip, with the car on the ground at normal ride height.
Smallest gap between the outer edge of the brake caliper and the inside of the wheel barrel.
- Poke
- 0mm
- Wheel face stays where it is.
- Inner clearance
- 0mm
- Same room to the suspension.
- Overall diameter
- 0%
- 0 in, within ±3%.
- Speedo reads 60
- 60mph
- Your actual speed.
| Vehicle | Chevrolet Colorado ZR2 | ||
|---|---|---|---|
| Bolt pattern | 6x120 | Hub bore | 66.9 mm |
| Current | 17×8 ET33, 265/65R17 | New | 17×8 ET33, 265/65R17 |
Popular upgrades
Each size compared with the stock 17×8 ET33, 265/65R17.
| Setup | Poke | Inner clearance | Diameter | Speedo reads 60 | Action |
|---|---|---|---|---|---|
| Skinny 33in 255/8017×8 ET33, 255/80R17 | 0 mm | 0 mm | +8.2% | 64.9 mph | |
| 33in 285/70 stock wheel17×8 ET33, 285/70R17 | 0 mm | 0 mm | +7% | 64.2 mph | |
| 34in 285/75 stock wheel17×8 ET33, 285/75R17 | 0 mm | 0 mm | +10.7% | 66.4 mph |
Notes
- Stock 265/65R17 is only about 30.5 in tall; owners fit 255/80R17 on the stock 17×8 ET33 wheels with no trimming, especially with extra caster.
- AEV's 33-inch clearance kit (closeout panels plus trim templates) is the usual route to 285/70R17 without a lift, and AEV says trimming is still needed to avoid contact at full articulation.
- 285/75R17 on stock wheels has been run with a level kit, the AEV trim and added caster; 35x12.50R17 (about 315/75R17) tires on stock wheels without spacers test-fit with under 1 inch to the upper control arm.
- The 6x120 pattern with M14x1.5 lug nuts is shared with all 2015-2022 Colorado/Canyon trims, so non-ZR2 wheels bolt on but sit inboard on the ZR2's wider track.
Questions
What bolt pattern does a 2017–2022 Chevrolet Colorado use?
The 2017–2022 Chevrolet Colorado uses a 6x120 bolt pattern with a 66.9 mm center bore and M14x1.5 lug threads.
What size wheels and tires are stock on the 2017–2022 Chevrolet Colorado ZR2?
The 2017–2022 Chevrolet Colorado ZR2 came with 17×8 ET33 wheels and 265/65R17 tires, about 30.6 inches in overall diameter.
How far does a 17×8 ET33 wheel stick out on a 2017–2022 Chevrolet Colorado?
On the 2017–2022 Chevrolet Colorado, compared with the stock 17×8 ET33, a 17×8 ET33 sits 0 mm further out at the outer lip and in the same place at the inner barrel.
Which 2017–2022 Chevrolet Colorado wheel and tire upgrade keeps the speedometer most accurate?
Of the 2017–2022 Chevrolet Colorado upgrades listed here, 17×8 ET33 · 285/70R17 is closest to the stock 265/65R17, changing overall diameter by +7%. At an indicated 60 mph you would actually be doing 64.2 mph.
Do aftermarket wheels need hub-centric rings on a 2017–2022 Chevrolet Colorado?
The 2017–2022 Chevrolet Colorado's hub bore is 66.9 mm. Wheels machined to exactly 66.9 mm center on the hub directly; wheels with a larger bore need 66.9 mm hub-centric rings to avoid vibration.