2017+ Alfa Romeo Giulia Wheel & Tire Fitment Guide
952 generation, Quadrifoglio. 5x110 bolt pattern, stock 19×8.5 ET34 on 245/35R19. Compare 2 popular upgrades or try your own size.
Specs
| Bolt pattern | 5x110 |
|---|---|
| Center bore | 65.1 mm |
| Lug thread | M14x1.5 |
| Reference trim | Quadrifoglio |
| Stock wheel | 19×8.5 ET34 |
| Stock tire | 245/35R19 |
| Stock overall diameter | 25.75 in |
Calculator
Starts on the stock setup. Drag the sliders or load one of the popular upgrades below.
The small mark on each slider shows the current value. Type in the box for sizes outside the slider range.
Custom vehicle measurementsOptional
Measure with your current wheels on the car and the results below show how much room the new setup leaves. The drawings use your numbers too. Leave blank anything you haven't measured.
- Park on level ground at normal ride height, wheels straight.
- Front and rear differ. Measure the axle you're changing, or enter the tighter corner.
Millimetres or centimetres are recommended: small gaps are easier to read accurately than inch marks.
Narrowest gap between the inside of the tire (or wheel, whichever sits further in) and the strut, spring perch or upper control arm. Wheels pointed straight.
Hang a plumb line or hold a straightedge vertically from the fender lip above the hub, then measure across to the outermost point of the tire or wheel. Enter a negative number if it already sticks out.
Straight up from the top of the tire to the fender lip, with the car on the ground at normal ride height.
Smallest gap between the outer edge of the brake caliper and the inside of the wheel barrel.
- Poke
- 0mm
- Wheel face stays where it is.
- Inner clearance
- 0mm
- Same room to the suspension.
- Overall diameter
- 0%
- 0 in, within ±3%.
- Speedo reads 60
- 60mph
- Your actual speed.
| Vehicle | Alfa Romeo Giulia Quadrifoglio | ||
|---|---|---|---|
| Bolt pattern | 5x110 | Hub bore | 65.1 mm |
| Current | 19×8.5 ET34, 245/35R19 | New | 19×8.5 ET34, 245/35R19 |
Popular upgrades
Each size compared with the stock 19×8.5 ET34, 245/35R19.
| Setup | Poke | Inner clearance | Diameter | Speedo reads 60 | Action |
|---|---|---|---|---|---|
| Street 19×919×9 ET30, 255/35R19 | +10.4 mm | −2.4 mm | +1.1% | 60.6 mph | |
| Wide 19×9.519×9.5 ET31, 265/30R19 | +15.7 mm | −9.7 mm | −1.9% | 58.9 mph |
Notes
- Rear stock: 19×10 ET41 with 285/30R19 (OE Pirelli P Zero Corsa, AR-marked).
- Uses M14×1.5 lug bolts with a 60° conical seat, not studs; the 5x110 / 65.1 mm hub is shared with the Stelvio.
- The Brembo 6-piston front calipers are the main clearance limit, so check spoke clearance on any front wheel.
- The 19×9 ET30 front setup is usually paired with a 19×10.5 ET42 rear on 295/30R19.
Questions
What bolt pattern does a 2017+ Alfa Romeo Giulia use?
The 2017+ Alfa Romeo Giulia uses a 5x110 bolt pattern with a 65.1 mm center bore and M14x1.5 lug threads.
What size wheels and tires are stock on the 2017+ Alfa Romeo Giulia Quadrifoglio?
The 2017+ Alfa Romeo Giulia Quadrifoglio came with 19×8.5 ET34 wheels and 245/35R19 tires, about 25.8 inches in overall diameter.
How far does a 19×9.5 ET31 wheel stick out on a 2017+ Alfa Romeo Giulia?
On the 2017+ Alfa Romeo Giulia, compared with the stock 19×8.5 ET34, a 19×9.5 ET31 sits 15.7 mm further out at the outer lip and 9.7 mm closer to the suspension at the inner barrel.
Which 2017+ Alfa Romeo Giulia wheel and tire upgrade keeps the speedometer most accurate?
Of the 2017+ Alfa Romeo Giulia upgrades listed here, 19×9 ET30 · 255/35R19 is closest to the stock 245/35R19, changing overall diameter by +1.1%. At an indicated 60 mph you would actually be doing 60.6 mph.
Do aftermarket wheels need hub-centric rings on a 2017+ Alfa Romeo Giulia?
The 2017+ Alfa Romeo Giulia's hub bore is 65.1 mm. Wheels machined to exactly 65.1 mm center on the hub directly; wheels with a larger bore need 65.1 mm hub-centric rings to avoid vibration.